Logo

P2828 BMW Fault Code

Check P2828 OBD Fault Code Reason
Description:

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

P2828 Code Symptoms :

See P2828 in engine

The P2828 Check Engine lamp is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. P2828 diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks with your car's computers to find out exactly what's prompting the light to turn on.

Diagnosis And Repairing P2828

P2828 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P2828 code ?

  • Engine Control Module (ECM)
  • Failures of clutch motion/travel sensors.
  • Faulty Air Flow Meter
  • Intake air leaks

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

BMW Cars that meet P2828 error